Battery Balancer

The battery balancer equalizes the state of charge of two series connected 12V batteries, or of several parallel strings of series connected batteries. When the charge voltage of a 24V battery system increases to more than 27V, the battery balancer will turn on and compare the voltage over the two series connected batteries. The battery Balancer will draw a current of up to 1A from the battery (or parallel connected batteries) with the higher voltage. The resulting charge current differential will ensure that all batteries will converge to the same state of charge.

If needed, several balancers can be paralleled. A 48V battery bank can be balanced with three Battery balancers.

Battery charger

The Victron Blue Power battery charger is a standalone charger which is directly connected to the national grid used to recharge deep cycle batteries when drained. The Blue power charger regularly checks the state of charge, voltage and reconditions the battery when in an unfavourable condition. The Victron Battery chargers include blue power IP 20/ IP 65

Adaptive four (4)-stage charge characteristic

The Blue Power charger goes through four charge stages to effectively and efficiently recharge batteries: Bulk, Absorption, Float and Storage.

  • The bulk charging stage is the charge cycle where the battery is fully drained
  • The absorption stage is next after recharging the battery to estimated 70%
  • The float charge stage is activated when the battery is fully charged
  • The storage charge stage occurs after a couple of hours from the float stage where charge voltage is minimized to the lowest.

MPPT Control

The MPPT Control lets you see the status as well as setup all BlueSolar MPPT Charge Controllers that have a VE.Direct communications port. The new MPPT Control is mounted in the familiar BMV-700 series housing, maintaining a consistent and professional look to your panels and systems monitoring equipment.

Battery Monitor (BMV 700-702 series)

The BMV-700 is a high precision battery monitor. The essential function of a battery monitor is to calculate ampere hours consumed and the state of charge of a battery. Ampere hours consumed is calculated by integrating the current flowing in or out of the battery.